Installation And Use - TEUFELBERGER EAP BEAM TROLLEY 7331929 Herstellerinformation Und Gebrauchsanleitung

5. INSTALLATION AND USE

Inspect the equipment according to INSPECTION of this manual before each use.
The EAP Beam Trolley could only be installed on any I-beam for horizontal position, and located on the
bottom of the I-beam.
Step 1 Remove the quick release lock pins. Then press the safety lock to adjust the trolley clamps.
Step 2 Place the EAP Beam Trolley onto beam flange on the bottom position of the I-beam.
Step 3 Place trolley clamp against one side of the beam flange. Slide the other trolley clamp against
opposite side of the beam flange. Ensure the D-ring is at the middle position of the I-beam.
ATTENTION: The I-beam must be closed on both sides so that the EAP Beam Trolley can't roll
out unintentionally.
Step 4 Ensure the safety lock is in nearest position to the beam flange.
Step 5 Insert the quick release lock pins to fix the safety locks, ensuring pins are locked into place.
Step 6 Ensure the quick release lock pins have not bottomed out. If quick release pins have bottomed
out, reinstall the trolley clamp to the next locking position. If the quick release lock pin is damaged
or absent, the equipment is still in a workable condition. However for safety concerning, when one
of the quick release lock pins is damaged or absent, the equipment must be sent back to your
dealers, distributors, or manufacturer to replace a new quick release lock pin.
INSTALLATION AND USE
Bottom Mount
15