Hama 00053116 Bedienungsanleitung Seite 22

You can change the following settings in the configuration menu:
Motor speed for controlling the camera
Speed:
Possible values: 1(fast) – 5(slow)
Resolution: Resolution of the live image.
The higher the resolution, the better the
image.
1024 x 768, 640 x 480 and 320 x 240 in
Possible resolutions:
MPEG4 image mode.
1280 x 1024, 640 x 480 and 320 x 240 in
H.264 and MJPEG image modes.
For setting the picture quality. Possible
Picture quality:
values: very low to very high
Image mode: Selection of image mode between
MJPEG, MPEG4 and H.264.
Refresh rate of the live image. A value of
Picture frequency:
30 is the equivalent of the refresh rate of
a TV image. If you connect the camera
via an Internet connection with a lower
bandwidth, you can reduce the
refresh rate.
Frequency: You can alter the frequency depending
on the lighting in the area under
surveillance. Options:
50Hz – predominantly daylight
60Hz – predominantly electrical lighting
Image reflections: Depending on the location / mounting
location of the camera, you can
configure the camera's live image.
E.g. if you mount the camera on a
ceiling, the image must be turned
by 180°. Otherwise it will appear upside
down. In addition to that, the image can
also be reflected horizontally
and vertically.
Specifying the
date and time: You can choose whether the current
time and date is to be displayed on the
camera's live image.
In the pop-up menu for „Brightness", you can adjust the
brightness, saturation and sharpness of the image.
Select the appropriate value and adjust it by pressing „+" or „-".
With the „+" and „-" buttons on the left and right of the blue bar,
you can adjust the camera's microphone volume.
Important: You must click „Apply" to apply your settings to the
camera.
22
Click „Snapshot" to save the live image currently
Snapshot:
displayed on the hard drive. As a rule, the
images are saved in C:\. You can change this by
changing the saving path in the entry field next to
the Snapshot button.
Recording: This button enables you to record an AVI video.
As a rule, videos are saved in C:\. You can change
this by changing the saving path in the entry
field next to the Snapshot button. To end
recording, click the „Record" button once more.
Full screen: The camera's live image is displayed on the whole
screen.
You can go back to the previous display by
pressing the „ESC" key on your keyboard.
Digital Zoom: Opens a new window with setting options for the
Digital Zoom function.
Check the „Enable" box to activate the Digital Zoom function.
Subsequently, you can use the slide control to set the zoom
factor to anything between 100% and 400%. In the live image,
you can select the field of vision for the enlarged live image my
means of the green frame.
Adjusting to window: The live image can be adjusted to the
size of the browser window.
Audio output via camera: You can use a microphone connected
to the PC to output spoken instructions
via the camera.
To do this, you need to connect a
loudspeaker to the camera. Hold down
the „Audio output via camera" button
until you have finished speaking.