Operation - roco 10882 Handbuch

Receiver Module Features at a Glance
▶ Multiprotocol operation possible (Motorola
▶ Fully-automatic flying change between all 4 operating modes
▶ Engine control
▶ Engine frequency: 20 kHz
▶ Support of braking distances
▶ 128, 28, or 14 driving stages in DCC operation and 14 driving stages in Motorola
▶ Programmable locomotive addresses
▶ NMRA-compatible
▶ The operating parameters can be comfortably changed: the locomotive does not have to be opened
▶ Direction-related lighting
▶ Shunting at the push of a button
▶ Acceleration and delay deactivation at the push of a button
▶ Overload protection
▶ Additional function outputs (the number depends on the decoder)
▶ RailCom
1)
▶ Can be updated
The decoder is only to be installed in model locomotives and cabins. A different use is not
permitted!
The Decoder can be used with both con-ventional neutral conductor-alternating current systems and neutral
conductor digital systems. The decoder has the special property of being able to automatically detect the
system. The decoders have the address 3 in the digital operation.
DCC operation
the vehicle can be operated with all DCC-conform systems.
Motorola

operation

3)
The vehicle can be used with all Motorola
with the so-called "new Motorola
on the Central Unit 6021 have to be set to the top position ("On").
DELTA operation
The vehicle decoder has been preset to the address 03 by the manufacturer so that the vehicle has to be
reprogrammed to a corresponding vehicle symbol for the allocated addresses before a Delta operation is
possible.
These addresses are: Steam locomotive:
Diesel locomotive:
E-locomotive:
Multiple unit:
Delta Pilot:
Owners of the DELTA system have the problem that it does not have a light switch. The vehicle can be so
altered however that the lights remain on (obviously in relation to the direction of travel). The requirement
for this is that the Central Unit 6021 THE CV 51 value is increased by 8.
Analogue operation
In analogue operation, the decoder acts as a conventional direction of travel commutator.
Digital, AC Analogue, DCC Digital, DC Analogue)
3)
Operation
and compatible systems. The functions F1 to F4 can only be used
3)
format" however. In order to activate these, the DIP switches 1 and 2
3)
78
72
24
60
80
operation
3)
GB
9