Technical Data - roco 10882 Handbuch

Programming instructions for the Märklin
A Märklin centre can be used to program all of the CVs but they cannot be read out.
2)
▸
The controller has to be set to "0".
▸
No locomotives are to be on the tracks except the one which is to be programmed!
▸
Please observe the locomotive lighting flashing signals during programming.
▸
Any number of changes/settings can be made as long as the decoder is in programming mode.
1. Press the STOP and GO buttons at the same time until a reset is carried out
2. STOP button until deactivation of the track voltage
3. Enter address 80
4. Press the direction of travel switch and keep it pressed in and then additionally press GO for at
least 0.5 sec in order to reactivate the track voltage
5.
The decoder is in programming mode = slow flashing
6. Enter the register which is to be changed (two figures in the address field)
7.
Confirm by pressing the direction of travel switch = rapid flashing
8. Enter the required value (two figures in the address field)
9.
Confirm by pressing the direction of travel switch = slow flashing
Note: You will find additional functions for this decoder at www.zimo.at

Technical Data

Addresses:
Max. engine current / total load:
Function outputs (each and in total):
Dimensions:
The decoder is preset at Address 03 with operating in 28 driving stages and can be driven and
programmed in DCC and Motorola
Decoder protection:
▸
Temperature protection the decoder deactivates and the lights flash rapidly at 100°C.
▸
Short circuit monitoring of the motor and function connections.
1) RailCom is a registered trademark of the company Lenz GmbH, Giessen
2) Märklin is a registered trademark of the company Gebr. Märklin & Cie. GmbH, Göppingen, Germany
3) Motorola is a registered trademark of the company Motorola lnc.,Tempe-Phoenix/Arizona (USA)
6020/6021
2)
data format
3)
.
1– 9999 (long DCC address)
1 A
0,8A each
20,0 x 11,0 x 3,5 mm (10882 and 10884)
22,0 x 15,0 x 3,5 mm (10883)
GB
15