C-Control GX107 Bedienungsanleitung Seite 70

Phone areas (only affects function INCALL):
As of firmware version 1.11d (indicated in every answering text message), you can defined phone
areas permitted for the "INCALL" function. Example:
If you want to release the following numbers for INCALL:
+491555512345
+491555523456
+491555534567
you can programme, e.g., the following phone number:
+4915555*****
The * are placeholders for any numbers.
Ensure that you have entered enough placeholders (*). The calling phone number is
compared to these place holders.
Important!
This also permits other combinations of phone numbers! You accept this risk when
using this function.
Deleting the phone numbers saved
To delete a phone number, send the following commands:
Example: To delete the 1st and 3rd phone numbers, you have to send 2 text messages:
RESET TEL1 #1513
RESET TEL3 #1513
To delete all phone numbers, send the following text message commands:
RESET TELALL #1513
After sending the command "RESET TEL...", you will receive a text message answer.
Testing phone number
To test the phone number stored in the "GX107", send the following text message command:
TEST TEL #1513
Always enter the complete phone number in international format (including country
code), e.g. +49... for Germany.
The text message commands (TEL1, TEL2, TEL3,...) change only the phone number
of the corresponding memory. The numbers of the other memories are retained.
You may change the phone numbers saved at any time.
70