Intended Use - C-Control GX107 Bedienungsanleitung

2. Intended Use

The GSM remote control/alarm module has 2 switching outputs that can be switched either via
text message or via call (INCALL).
An analogue input (ADC) can measure both an external voltage and be reconfigured to use an
optional temperature sensor (Conrad item no. 198896).
The optocoupler input (IN1) is used to supervise switching signals. Accessories available include
a GPS receiver (Conrad item no. 1629152) to determine the current GPS position as well as to
indicate when leaving determined areas.
The configuration, communication and alarms are sent via text message in the "GX107". Alarms
can be sent to an email address if the GSM provider used supports this function.
Typical applications are switching of door openers, garage door openers, lighting and alarm
systems, inspecting door sensors, motion detectors, fire alarms or fill level sensors, as well as
generation of alarm messages.
The optional GPS receiver also enables monitoring of moving objects.
All connections are approved for line lengths of no more than 1 m. Designated accessories are
not affected by this.
Read these operating instructions thoroughly and carefully, they contain a lot of important infor-
mation for assembly, commissioning and operation.
Any use other than that described above is not permitted. Misuse may not only damage the device,
but also leads to risks such as short circuit, fire, electric shock. The product must not be modified
or converted. The safety information and the maximum permissible operational and ambient
conditions stated in the chapter "Technical Data" must be observed at all times.
This product complies with the statutory national and European requirements. All company names
and product names are trademarks of their respective owners. All rights reserved.
53