Philips PerfectCare 9000 Serie Bedienungsanleitung Seite 11

Problem Possible cause
Steam is reflected from the ironing
board and condenses on the iron.
Water droplets come The steam that was still present
out of the soleplate. in the hose has cooled down and
condensed into water. This causes
water droplets to come out of the
soleplate.
Some steam comes out The iron has rested for a longer
of soleplate when iron period of time and is regulating to
is resting. ensure that the soleplate is at the
right temperature during rest. This is
normal.
Steam and/or water The EASY DE-CALC knob is not
come out from under tightened properly.
the EASY DE-CALC
knob.
The rubber sealing ring of the EASY
DE-CALC knob is worn.
Dirty water and Impurities or chemicals present in the
impurities come out water have deposited in the steam
of the soleplate or the vents and/or on the soleplate.
soleplate is dirty.
Too much scale and minerals have
accumulated inside the appliance.
The iron leaves a shine The surface to be ironed was uneven,
or an imprint on the for instance because you were ironing
garment. over a seam or a fold in the garment.
The appliance does not There is not enough water in the
produce any steam. water tank (the 'low water alert' light
flashes).
The appliance is not hot enough to
produce steam.
The automatic steam mode is off and
you did not press the steam trigger.
The water tank is not placed in the
appliance properly.
The appliance is not switched on.
The Easy De-calc light is on.
Solution
Use a board/board cover that allows steam to
penetrate through.
Steam away from the garment for a few seconds.
If the steam continues for a long period when
the iron is resting, switch off the appliance and
remove the plug from the wall socket. Contact an
authorised Philips service centre.
Switch off the appliance and let the appliance
cool down for 2 hours. Unscrew the EASY DE-
CALC knob and screw it back onto the appliance
properly. Note: Some water may escape when you
remove the knob.
Contact an authorised Philips service centre for a
new EASY DE-CALC knob.
Clean the soleplate with a damp cloth.
Descale the appliance regularly (see chapter
'Important - EASY DE-CALC' and 'Important
-Descaling the soleplate').
ActiveSense is safe on all ironable garments. The
shine or imprint is not permanent and will come
off if you wash the garment. Avoid ironing over
seams or folds or you can place a cotton cloth
over the area to be ironed to avoid imprints at
seams and folds.
Fill the water tank (see chapter 'Using your
appliance', section 'Getting the product ready').
Wait until the 'iron ready' light on the iron lights
up continuously.
Press the steam trigger and keep it pressed while
you iron or ensure that the automatic steam
mode is on.
Slide the water tank back into the appliance firmly
('click').
Insert the plug in the wall socket and press the
on/off button to switch on the appliance.
Descale the appliance (see chapter 'IMPORTANT
- EASY DE-CALC').
ENGLISH
13