HELIOSA HI DESIGN 66 BLACK Gebrauchsanweisungen Seite 16

4. INSTALLATION TO WALL
Install the heater on the wall at a minimum distance of 32 cm from the ceiling (see installation examples on page 5 ). The
height at which the heaters are normally installed varies from 2,2 m to a maximum of 2,5 m . Wall mounting is the ideal
solution to achieve the best results in terms of heat with the reflector at a 45° angle and the heater perfectly horizontal.
The appliance must not be placed immediately below a mains socket.
5. POSITIONING OF HELIOSA® HI DESIGN 66 BLACK
Aim the HELIOSA® 66 reflector in the direction required for the wall-mounted installation. The normal angle is 45° to the
1.
horizontal plane.
Never install HELIOSA® 66 an inflammable surface or facing an inflammable surface.
2.
HELIOSA®66 must be placed at a clear distance (line of vision) of not less than 2,0 m from objects such as cardboard,
3.
fabrics, curtains and windows. If used in workshops and garages where there are inflammable paints, HELIOSA 66 must be
located more than metres from the hazard.
We recommend that the heater is not used in dusty non-ventilated environments to avoid damage to the bulb.
4.
8.MAINTENANCE AND REPLACEMENT OF BULB
(TO BE PERFORMED BY QUALIFIED STAFF OR SPECIALIZED TECHNICIAN)
THE GUARANTEE DOES NOT COVER REPLACEMENT OR REPAIR OF BULB.
•
REPLACEMENT OF BULB IS TO BE PERFORMED ONLY BY PROFESSIONALLY QUALIFIED PERSONNNEL OR BY A SERVICING
•
CENTRE.
REMOVE DUST FROM THE REFLECTOR AND BULB PERIODICALLY WITH BRUSH OR COMPRESSED AIR FOR CONSTANT
•
HELIOSA® HI DESIGN 66 BLACK HEAT EFFICIENCY.
THE REPLACEMENT BULB MUST BE THE SAME AS THE BULB SUPPLIED WITH THE DEVICE.
•
REPLACEMENT WITH OTHER BULBS MAY DAMAGE THE DEVICE AND CAUSE IT TO BE UNSAFE. CONTACT STAR PROGETTI
•
OR THE RETAIL OUTLET AUTHORIZED TO SELL THE REPLACEMENT BULB, SPECIFYING THE MODEL AND CODE OF THE
PURCHASED HEATER.
THE INJECTION POINT ON THE BULB (c) MUST ALWAYS FACE OUTWARD.
•
BEFORE PROCEEDING WITH BULB REPLACEMENT, OPERATORS MUST:
FULLY DISCONNECT THE DEVICE FROM POWER SUPPLY AND MAKE SURE THE BULB IS COLD
1.
NOT TOUCH THE BULB WITH THEIR BARE HANDS.
2.
BULB REPLACEMENT
66BKX5 2000W
66BKX5C 2000W
39
16