Maintenance Plan; Air Filter Cleaning; Condensation Water; Storage - Zipper Maschinen ZI-COM200-10 Betriebsanleitung

13.2

Maintenance plan

Loose or lost screws, nuts, bolts
Damage of any part of the machine
Oil level
Machine cleaning

Air filter cleaning

Oil changing
13.2.1 Air filter cleaning
The intake filter prevents dust and dirt being drawn in. It is essential to clean this filter. A clogged
intake filter will decrease the compressor's performance dramatically. Open the air filter housing and
remove the air filter. Use compressed air at low pressure (approx. 3 bar) to blow out all the parts of
the filter and then assemble the filter in reverse order.

13.2.2 Condensation water

To ensure a long service life of the pressure vessel, drain off the condensed water by opening the drain
cock each time after using.
The condensation water from the pressure vessel will contain residual oil. Dispose of the
condensation water in an environmentally compatible manner

13.2.3 Storage

If the machine is stored for longer than 30 days:
• Let the machine cool down
• Clean the machine and dry
 Depressurize the air tank.
• Store in a dry, out of reach of children place, well packaged (protection against cuts)
13.3

Disposal

Do not dispose the machine, machine components fuel and oil in residual waste. Contact your
local authorities for information regarding the available disposal options. When you buy at your
local dealer for a replacement unit, the latter is obliged to exchange your old.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-COM150-10 ; ZI-COM200-10
Controls for the maintenance of the machine
Regularly prior to each operation
Regularly prior to each operation
Regularly prior to each operation
Regularly after operation
Every 20-30 working hours
Every 250 working hours
MAINTENANCE
22