Air Filter; Operation Instructions - Zipper Maschinen ZI-COM200-10 Betriebsanleitung

Air filter:

Mount the air filter like on the
picture.
Remove any blank cover previously!
Oil:
Place machine on a level ground.
Open the oil filler. Fill in Oil SAE30
until it reaches the middle mark of
the oil sight glass. Close oil filler
ATTENTION! For transport oil has been drained. Fill up with oil SAE30
before first operation! Failure to do so will result in permanent engine
damage and void guarantee!
12 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
12.1

Operation instructions

Perform all machine settings with the machine being
 The oil level in the compressor pump has to be checked before each use
 The machine should be set up near the working consumer. Avoid long air lines
and long supply lines (extensions).
 Make sure the intake air is dry and dust-free.
 Do not set up the machine in damp or wet areas.
 The machine must be operated on firm, level ground
 Safety valve must be closed before the start
 When removing the hose coupling, hold the coupling piece of the hose is by
hand. So the injury from rebounding hose is avoided
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-COM150-10 ; ZI-COM200-10
W A R N I N G
WARNING
disconnected from the power supply!
NOTICE
OPERATION
20