Before Operation; Setting The Clock; Kitchen Timer Function - Sharp R260 Bedienungsanleitung

BEFORE OPERATION

Plug in the oven. The oven display will display: "1:00", an audible signal will sound once.
This model has a clock function and the oven uses less than 1.0W in stand by mode.
To set the clock, see below.

SETTING THE CLOCK

Your oven has a digital clock feature, you can choose to set the clock time in 24 or 12 hour
cycle in stand by mode.
1. Press the KITCHEN TIMER/SET CLOCK key once for 3 seconds, " Hr 24" will display and the
indicator " " will illuminate.
2. Press the KITCHEN TIMER/SET CLOCK key twice, ''Hr 12" will display and the clock indi-
cator " " will illuminate.
3. After choosing the hour cycle, press number keys '' 10Min'' , ''1Min'' , ''10Sec'' to input the
clock time .
4. Press the KITCHEN TIMER/SET CLOCK key once to start the clock. The icon '':'' of the digi-
tal time will flash on the display and the indicator "
NOTES:
• In the process of clock setting, if the STOP/CLEAR key is pressed, the oven will go back to
the former setting.
• If the electrical power supply to your microwave oven is interrupted, the display will in-
termittently show „1:00" after the power is reinstated. If this occurs during cooking, the
programme will be erased.

KITCHEN TIMER FUNCTION

You can use the kitchen timer function, in instances where microwave cooking is not in-
volved for example to time boiled eggs cooked on conventional hob or to monitor the
standing time for cooked/defrosted food.
Example:
To set the timer for 5 minutes.
1. Press KITCH-
EN TIMER/
SET CLOCK
keyonce,the
icon ''0:00'' will fash
and the clock
indicator " "will
illuminate.
When the timer arrives at 0:00, an audible signal will sound twice and the LCD will then
display the time of day.
You can enter any time up to 99 minutes 50 seconds. To cancel the KITCH EN TIMER whilst
counting down, simply press the STOP/CLEAR key.
NOTE: The KITCHEN TIMER function cannot be used whilst cooking.
2. Press number
keys ''10Min'' ,
''1Min'' , ''10Sec''
to input time .
GB-17
" will disappear.
3. Press the START/
QUICK START
key to start the
timer.
4. Check the display.
(The display
will count down
through the pro-
grammed time
and the indicator
will flash)