Operation; Control Panel; Operating Modes - Laserworld Club Serie Bedienungsanleitung

Manual / Bedienungsanleitung: CS-400 RGB
Make sure to use the correct voltage. Always use a grounded mains connection. Don't use a remote
controlled or other electronically switched main connection. Don't use together with large
appliances (especially fog machines/hazers) on the same mains.
If the device is used in a flying installation, the mounting brackets and an appropriate safety-rope
must be fixed.
In some countries, the operator must notify the accidence insurance and the authority for industrial
safety, before operating a laser. For more information, contact the relevant authorities.
Please consider that unauthorized modifications on the device are strictly forbidden due to safety
reasons!
If this device will be operated in any way differently than described in this manual, the product may
suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to
dangers like short-circuit, burns, electric shock, etc.
Keep surrounding dry and clean.
dusty environment, don't place liquid filled receptacles on the device. Projector should be put in a
water-proof housing when operated outside.
Regularly open the device (see "cleaning" further down) to check for dust inside, or if fog fluid
condenses in the housing (if so rearrange hazer and/or laser position).
Operating temperature is 10~35° C . In a new installation, check after some 15-30 minutes whether
the outlet air gets too warm. Regularly check the inside for dust deposits, especially around the
fans. Let laser cool off 10 minutes after 2 hours of operation, to ensure maximum lifetime for the
diode. Be careful not to direct stage lights toward the laser (especially moving heads), this can
cause overheating.
Distance between laser aperture and projection screen should be not less than 1 meter.
Do not turn device on and immediately off again frequently.
Do not look into the laser beam directly, especially not with optical instruments.
Do not touch the device with wet hands.
When the laser diode becomes dim or broken, please contact your dealer timely.
When returning laser to dealer/manufacturer always use original packaging.
Maintenance should be performed every 15-day period. See "cleaning" further down.

Operation

Caution – use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
Connect the power cable to the mains. Connect an emergency switch to the interlock connector,
turn on device. The red LED on the front panel should turn on, and the laser beam will exit through
the front opening – be careful.

Control panel

1 Powe switch
2 Remote lock, connect emergency switch
3 Dip switch, mode/DMX address selection
(see below)
4 DMX 512 in/out
5 Microphone sensitivity
6 Microphone
7 Safety switch Laser on/off
8 ILDA connector

Operating modes

The following operating modes can be selected
from the DIP switch on the backside of the device:
Dip switch
0,0,0,0,0,0,0,0,0,0
1,0,0,0,0,0,0,0,0,0
"Music activ": patterns are changed/animated to the beat of the music. Sensitivity can be adjusted at the back panel.
"Automatic mode": patterns are changed automatically
This unit should be keep dry, do not use in the rain or damp and
Mode
Music active, beam effects
Automatic mode, beam eff.
Page / Seite 4 of / von 12
1,1,0,0,0,0,0,0,0,0
x,x,x,x,x,x,x,x,x,1
Automatic mode, graphics
DMX
Version / Stand: 03/2010