Troubleshooting; Ilda Signal; Technical Specifications; Please Note - Laserworld Club Serie Bedienungsanleitung

Manual / Bedienungsanleitung: CS-400 RGB

Troubleshooting

Problem
No function / fan not working
Effects don't change to the beat of the music
Problems with DMX control
Device not working, but fan working
Laser does not switch to ILDA mode:
• The interface does not connect pins 4 and 17 (Interlock) of the IDLA signal. See interface manual
• The cable does not connect pins 4 and 17. Use a cable that connects pins 4 and 17.
• Use an adapter, that connects pins 4 and 17.

ILDA signal

Pin out of the standard ILDA signal:
1 Scanner X+
2 Scanner Y+
3 Intensity/Blanking+
4 Interlock A
5 Red+
6 Green+
7 Blue+
8 – 12 Not used
13 Shutter +5V, max. 20 mA

Technical specifications

•
Power supply: AC 85V-250V, 50/60 Hz
•
Ambient temperature: +10°C ... +35°C
•
Power consumption: 50 W
•
Operation modes: DMX 512, automatic, music mode, ILDA
•
Lasersources: aircooled DPSS laser (green, blue), diode laser (red)
•
Optical power (at the laser):
min. 250mW, max 400mW;
>60mW 532nm green, >150mW 655nm red, 40mW 473nm blue
•
Beam: ca. 3mm/1mrad
•
Laser class: 3b
•
Scanning system: Galvo system, 25.000 PPS at 4°
•
Scanangle: max 40°
•
Weight: 6.5 kg
•
Dimensions: 37 x 27 x 15 cm (W x D x H)

Please note

This device has left our premises in absolutely perfect condition. In order to maintain this condition
and to ensure a safe operation, it is absolutely necessary for the user to follow the safety
instructions and warning notes written in this user manual. Laserworld cannot be made liable for
damages caused by incorrect installations and unskilled operation!
This manual is subject to changes without notification, errors and omissions expected. Contact your
local dealer for an update, or check our website www.laserworld.com
For service contact your dealer, or Laserworld.
Possible cause
Check mains connection
Adjust sensitivity with the dial on the back.
Check if device isn't in DMX or autom. mode
Check DMX address selection
Turn device off for ca. 1 Minute.
-10V..+10V
-10V..+10V
0V..+2.5V
0..2.5V
0..2.5V
0..2.5V
Page / Seite 6 of / von 12
14 X-
15 Y-
16 Intensity/Blanking-
17 Interlock B
18 Red-
19 Green-
20 Blue-
23-24 Not used
25 GND Signal ground
+10V..-10V
+10V..-10V
0..-2.5V
0..-2.5V
0..2.5V
0..-2.5V
Version / Stand: 03/2010