General Safety Rules - Waterco W9918 Installation Und Betriebsanleitung

GENERAL SAFETY RULES

1. The machines mentioned in the manual are specially designed for the pre-filtering and re-
circulation of water in swimming pools.
2. They are designed to work with clean water at a temperature not exceeding 35 degrees Celsius
(95 degrees Fahrenheit).
3. The installation should be carried out in accordance to the safety instructions of swimming pools,
especially Standard HD 384.7.702, and the specific instructions for each facility.
4. The rules enforce on accident prevention should be carefully followed.
5. Any modification of the pump requires the prior consent of the manufacturer. Original
replacement parts and accessories authorized by the manufacturer ensure a high level of safety.
The manufacturer of the pump assumes no liability for the damage and injuries caused by
un-authorized replacement parts and accessories.
6. During operation, some parts of the pump are subject to dangerous electric voltage. Work may
only be performed on each pump or on the equipment connected to it after disconnecting them
from the mains power, and after disconnecting the starting device.
7. The user should make sure that assembly and maintenance tasks are carried out by qualified
authorized persons and that these persons have first carefully read the instructions for service
and installation.
8. The operating safety of the pump is only guaranteed if the installation and service instructions are
correctly followed.
The limit values stated in the. Technical table should not be exceeded under any condition.
9.
10. In the event of defective operation or fault, contact the technical support department of the
manufacturer or its nearest authorized agents.
11. If the supply cord is damaged, it must be replaced by an authorized service agent.
12. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
13. The appliance is not intended for use by young children. Young children should be supervised to
ensure that they do not play with the appliance.
14. All wiring (electrical work) must be carried out by licensed electricians and must be installed in
accordance to the local codes.
15. If the pump is to be installed on a swimming pool or pond situation it is mandatory that an earth
leakage circuit breaker with a rated tripping current not exceeding 30mA be installed.
For Use in Europe:
1. This appliance is not intended for use by persons (including children aged from 8 and above)
with reduced physical,sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
3. Cleaning and user maintenance shall not be made by children without supervision.
Waterco Pumps
I pg 01