Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Produktgruppe 512, 522
36 von 36
Push the 4 brackets (Fig. 6, Pos. 1) over the machine feet.
Insert the 4 M6 hex screws (Fig. 6, Pos. 2) with B6.4 washers (Fig. 6, Pos. 3) from above into the existing holes.
Secure the 4 brackets from underneath using the 38-millimeter washers Fig. 6, Pos. 4), B6.4 washers (Fig. 6, Pos. 3) and M6 hex
nuts Fig. 6, Pos. 5).
Danger!
Risk of tipping or crashing! Securing the stand to the floor and the machine to the stand is absolutely necessary!
Note
For floor/wall drain connection, see PW 6080 installation plan .
Note
Mounting material for floating screed is to be provided on site.
UG 6008 Stand
Secure the 2 side panels using M4 x 12.4 (Torx 20) screws; see Fig. 7.
Secure the front panel using M4 x 12.4 (Torx 20) screws; see Fig. 7.
Carry out appropriate electrical safety checks.
Reconnect the machine to the power supply (and gas supply, if applicable).
Carry out a test run of a service program or a wash program. Check for leaks at the drain connection in the machine and the drain
connection at the wall (or floor).
am
27.10.2009
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 07707490
Werbung
