Miele 512 Serie Umbau- Und Montageanweisung Seite 34

Produktgruppe 512, 522
34 von 36
am
Parts required
Quantity Mat. no.
1 07689330
1 07129240
Note
Service and repair work should only be carried out by a suitably qualified electrician (with specialist training, knowledge and experience,
and recent related work experience) in accordance with all appropriate local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance with all appropriate
legal requirements, accident prevention regulations and valid standards.
Note
Service and repair work on gas machines should only be carried out by suitably qualified persons in accordance with all appropriate local
and national safety regulations. Ensure that all special regulations applying to gas installations (DVGW G 676) are also complied with.
Before starting any service work, the machine must be disconnected from the gas supply.
Danger!
Even with the machine switched off, supply voltage may be applied to some components.
Before starting any service work, the machine must be disconnected from the power supply. Suitable measurements must be made to
ensure that this is the case.
A general visual check should always be carried out.
Incorrect conversion or service work could lead to a risk of fire or gas explosion.
Danger!
Risk of injury during installation:
Danger of electric shock. Before starting any service work, all voltage-carrying components must be disconnected from the power
supply.
Only install this stand on machines that are uninstalled. For uninstallation instructions, see the machine's operating manual.
Wear non-skid gloves and shoes.
Make sure that no body parts, especially hands and feet, can get stuck under or between machines.
Make sure that no children or pets are in the work area during installation.
Risk of spinal injury. Keep in mind the weight of the machine in respect to your own body weight. For machine weights, see the
operating manual.
Danger of tipping due to incorrect installation.
Always bolt the machine(s) and stand(s) together.
When installing only one stand, secure it to the floor using foundation kit no. 01497252.
When securing, all four of the stand's feet must be on the floor.
Do not use the stand for a washer/dryer combination.
27.10.2009 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
UO 6008 installation kit
UG 6008 installation kit
M.-Nr. 07707490