Installation; Installation Of In.k1000 - Gecko in.k1000+ Bedienungsanleitung

+
1

Installation

Installation of in.k1000+

To install the in�k1000+, use the drilling template provided in this section�
Determine the mounting location and stick the template on the chosen location�
Cut out an opening according to the template (see illustration)�
Clean the installation surface and peel the adhesive gasket from the back
of the keypad�
Insert the keypad and align it correctly, then ensure it is properly glued
by gently pressing evenly on the entire surface�
Gasket with or without adhesive
Optional wing nuts
and spacers
6