Configuration; Trouble Shooting - Alde Smart Control Betriebs- Und Installationsanweisungen

10. ConfIgurAtIon

The Alde Smart Control should be configured after installation. To do so, use the Alde
Smart control App on your smartphone and go to the Settings Menu.
Enter the phone number to the SIM card inserted into the module (Smart Control Tel. no.)
and alerts phone number in the app, set the PIn code and type of heating system. The PIn
SEND
code is not the same as your SIM card PIn code. It is a PIn code you can use to avoid
that someone else sends your Alde Smart Control module an SMS text message. Press
Send, and also the send button for the SMS text message that shows up. The information
is saved and sent to the module.

11. trouble ShootIng

If your Alde Smart Control system does not answer when an SMS text message is sent from the
App, try the following:
1. Check if 12V is connected and reaches the module. Be aware of the current used by the system
when in standby, so depending on the battery status it can drain your battery after 1-2 months.
2. Make sure the temperature where the module is located is > -30°C.
3. Check if there is a GSM signal close to the module, e.g. with another mobile phone.
4. Check if the antenna is connected to the module.
5. Remove the 12V for 5 minutes and reconnect it again.
6. If there is a high load on the GSM network it can take longer time until you get an answer from
the module.
7. The button on the module is flashing. This is fully normal on some occasions and when it stops
to flash the system works again:
• The system sometimes restarts and the diode is flashing for approximately 1 minute.
• If the module does not find a 2G network.
• If the module does not find the SIM card.
• If the SIM card has been taken out from the module without disconnecting the 12V.
8. If you get an error messages in an SMS text message, read the Alde panel instruction to find out
the root cause.
(*) Requires optional parts, not included.
All manuals and user guides at all-guides.com
23