Possible Cause - 969.Coffee ELBA IV V 01 Bedienungsanleitung

Problem
Little or no crema
Reduced coffee flow
Weak coffee
Foam instead of crema
Machine is switched on,
but no water is released
from the brew
group.
Brew group releases
steam/temperature for
coffee preparation
is too high
No steam / steam not
working
The coffee dispensing is
irregular.
TROUBLESHOOTING

Possible Cause

The grind is not fine enough.
The coffee is too old.
More grounds are needed.
The shower screen is dirty.
The grind is too fine.
Excess grounds are being used.
The water tank is empty.
The grind is not fine enough.
The coffee is old.
Not enough grounds being used.
The shower screen is dirty.
The coffee beans are improper.
The grind setting is not suitable for the
coffee beans in use.
Water is low in the tank.
The boiler is empty after steaming
The water tank was inserted incorrect.
The steam switch is switched on.
The water tank is empty.
The boiler is empty.
The nozzle is blocked.
The filter is blocked.
The grind is not correct.
Troubleshooting
User a finer grind.
Use fresh coffee.
Use 7 g. – 9 g. of coffee per cup.
Clean the brew group.
Use a coarser grind setting.
Use ~7g-9g of coffee for every cup.
Refill the water tank.
Reduce the grind setting.
Use fresh coffee.
Use ~7g-9g of coffee for every cup.
Clean the shower screen.
Use another coffee bean.
Dial in the grind setting to the
appropriate size.
Refill the water tank with water.
Allow the boiler to refill after
steaming.
Reinsert the water tank properly.
Switch off the steam switch.
Refill the water tank and release
water from the brew group.
Allow the boiler to refill.
Clean the nozzle.
Clean the filter.
Change the grind.
15