External Control; Dmx Control - Jinbei EF-300 Anleitung

• In the settings menu, you can select whether you want to
control the LED light by 2.4 GHz radio signal, Bluetooth* or

DMX control.

The relevant symbol appears in the top left-hand corner of
the display.
• 2.4 GHz radio signal: this LED permanent light is compatible
with the EF-RC LED remote control. With the 2.4 GHz radio
signal set, you can use the rotary knob to set the channel and
group.
• By briefly pressing the setting knob, the channel display
starts flashing and you can set one of 32 channels (00 - 31)
using the setting knob.
Jinbei App/Bluetooth*
Download the „Jinbei" app directly from the App Store or the
„Jinbei Studio" app from Google Play Store (iOS 9.0 or higher,
Android 5.0 or higher)
Connection with the smartphone
1. Activate Bluetooth®* on your smartphone.
2. Switch on the Jinbei EF-300 and activate Bluetooth* in the
settings menu.
3. Open the "Jinbei (Studio)" app and the connection to your
smartphone will be established automatically.
Note: If you wish to connect the LED light to the app on
another smartphone, go to the menu to reset the Bluetooth*
signal.
Note:
• The connection is established using „Bluetooth* Low Energy"
(BLE). For this, a location release of the app is required. The
connection to the LED light is produced directly in the app.
Download on the
DMX control
Connect the LED permanent light to your DMX controller via the
DMX connections "IN" and "OUT".

External control

• Pressing the setting knob again causes the group display to
start flashing and you can use the Use the setting knob to set
one of 16 groups (A - J / L / O / P / Q / S / U).
• Confirm the settings by pressing the setting knob.
• When using radio remote controls, note that for correct ope-
ration, the radio channel and the group must be set identi-
cally on each LED permanent light and on the remote control.
It is also possible that not all functions can be set with the
remote control.
• Note that the radio frequency (2.4 GHz) used by these de-
vices is shared with other users/devices. This means that
interference cannot be ruled out. If necessary, change the
radio channel to avoid interference.
9