Settings Menu - Jinbei EF-300 Anleitung

Power supply
• Insert the supplied power cord into the power cord connector
of the continuous light.
Press the on/off switch to position „I" to switch on the LED
light. In position „O", the light is switched off.
Compatibility of accessories
• The LED permanent light is equipped with an umbrella holder
for reflex/transmitted light umbrellas and the Bowens S-ty-
pe bayonet for the use of various light shapers (softboxes,
reflectors, beauty dishes, etc.)
• Insert the light shaper with the three bayonet pins into the
corresponding recesses on the LED lighting head and lock
it by turning it briefly to the right until it audibly clicks into
place.
• To remove the light shaper, pull the bayonet release button to
the rear, turn the light shaper to the left and pull it off to the
front.
U-bracket
To enable the LED light to also
be mounted from above (e.g.
on the ceiling), the unit is
attached using the useful
U bracket. You can loosen the
knobs on the sides, turn the
bracket around and mount it
again from above. This ensu-
res that the heat is still reliably
dissipated.
Brightness
Adjust the brightness:
• After power on, turn the adjustment knob clockwise to in-
crease the brightness and counterclockwise to decrease the
brightness.
• The brightness can be adjusted between 0% and 100% in 1%
increments.
Lighting effects
You can use the LED permanent light to create various lighting
effects. To do this, briefly press the light effect mode button to
access the effects. By briefly pressing the light effect mode but-
ton again, you can now choose between the different modes:
1: TV flicker
2: Flickering light bulb
3: Fireworks
4: Thunderstorm mode
5: Flashing mode
After selecting the desired lighting effect, briefly press the
adjustment knob to set the effect. Press once to access the
brightness setting, press again to access the frequency setting.
By turning the setting knob at a time, you can adjust the bright-
ness between
0 – 100% and the frequency between 1 – 10. 1 describes the
slowest and 10 the fastest frequency.
• Modes 1 and 2 run continuously, modes 3, 4 and 5 play short
light sequences. To start them, briefly press the lighting effect
start button.
• To switch off the lighting effects, press the return button.

Settings menu

• Press the Menu key to display the Settings menu.
• Briefly press the setting button to scroll through the options.
When an option is selected, the icon turns green. Turn the
setting knob to select the setting, confirm by briefly pressing
the setting knob and press the return key to return to the
menu.
The settings menu contains the following options:
• Cooling: Auto / On / Off
• Communication: Radio
signal over 2.4 GHz /
Bluetooth* / DMX
• Reset Bluetooth*:
Yes / No
• Language setting:
Chinese / English
• Factory settings:
Yes / No
• You can switch the cooling system of the LED light on or off.
To do this, go to the settings menu and switch off the cooling
system via the first setting point. The symbol in the display
indicates whether the cooling system is switched on or off.
• Please note that when the cooling system is switched off, the
LED light can only be operated at a maximum output of 30%
to protect it from overheating. This reduced power is never-
theless indicated as 100% power.
8
Cooling