Klarstein MAXFLOW SMART Bedienungsanleitung Seite 22

EN
22
Air cooling mode
Note: In order for the water to be cooled down for the air cooling mode, place the
ice box in the freezer for 2 hours and then place the box in the water tank on the left
side.
Before turning on the unit, fill the water tank with a maximum of 5 liters of water and
insert it into the unit. Before inserting it, make sure that the honeycomb filter is inserted.
Press the COOL button to activate the air cooling mode, the corresponding indicator will
light up. The water is pumped up, runs through the honeycomb filters and cooled down
air flows out of the air outlet at the front. Press the COOL key again to deactivate the
cooling mode. The indicator light goes out.
Water alarm
In air cooling mode, the unit will shut down when the water capacity in the tank drops
below the warning level. The water alarm icon flashes red to remind the user to refill
water. The indicator light will turn off and the unit will continue to operate when enough
water has been refilled.
Water purge alarm
This function reminds the user to clean the water tank regularly to prevent bacteria from
multiplying. If the water remains in the tank for more than 3 days in standby mode, all
indicators will flash to remind you to clean the tank and fill fresh water before use.
Ionizer function (not available on all units)
If the ionizer function is available on your unit, press the ION button, the indicator will
light up and the function will be activated. Press the ION key again, the indicator goes
off and the function is terminated.
Turn on WIFI function
Turn on the unit, the WIFI indicator will light up and flash quickly. As soon as you have
connected the air cooler to your smartphone as described in the chapter Device control
via smartphone, the WIFI indicator lights up constantly. Press the WIFI button for 3
seconds to reset the connection. The display will then flash again.