Overload Protection; Overheat Protection - Makita DBN600 Betriebsanleitung

Overload protection

When the tool/battery is operated in a manner that
causes it to draw an abnormally high current, the tool
automatically stops without any indication. In this sit-
uation, turn the tool off and stop the application that
caused the tool to become overloaded. Then turn the
tool on to restart.

Overheat protection

When the tool/battery is overheated, the tool stops
automatically. In this situation, let the tool/battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically and the battery indicator shows following
state. In this case, remove the battery from the tool and
charge the battery.
On
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.2: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Off
Blinking
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Trigger-lock button
CAUTION:
When not operating the tool,
depress the trigger-lock button from B side to
lock the switch trigger in the OFF position.
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided.
To pull the switch trigger, depress the trigger-lock button
from A side.
After use, always press in the trigger-lock button from
B side.
► Fig.3: 1. Trigger-lock button 2. Switch trigger
Nailing mode selection
The tool employs two nailing actions. Select the desired
nailing by the mode selecting switch.
► Fig.4: 1. Mode selecting switch 2. Sequential mode
3. Continuous mode
Intermittent nailing (sequential mode)
This mode suits for driving a nail carefully and
accurately.
Continuous/ intermittent nailing (continuous mode)
When the tool is set to this mode, you can choose either
continuous or intermittent nailing by sequences of the
trigger operation.
Adjusting the nailing depth
WARNING:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before adjusting the depth of nailing.
Turn the adjuster to adjust the nailing depth. The nailing
depth gets deeper as you turn the adjuster to A direc-
tion, shallower to B direction in the figure. The range of
the nailing depth adjustment is 3 mm.
► Fig.5: 1. Adjuster
NOTICE:
Do not turn the adjuster too much, or
the adjuster may get stuck.
Adjust the nailing depth as necessary.
► Fig.6: 1. Too deep 2. Flush 3. Too shallow
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger or actuate the contact element to
light up the lamp. The lamp keeps on lighting while pull-
ing the switch trigger or actuating the contact element.
The lamp goes out approximately 10 seconds after
releasing the switch trigger and the contact element.
► Fig.7: 1. Lamp
8 ENGLISH