Safety Instructions - cecotec TOTALPURE 3IN1 VISION Bedienungsanleitung

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the wall outlet is
grounded.
This product is intended for household and indoor use, not
commercial.
Do not leave the product unsupervised during operation.
Always unplug the product from the electrical outlet when it
is not use.
Place the product on a flat, steady, stable, heat-resistant
surface.
Do not use the device in areas where gasoline, paint, or
flammable liquids are used or stored, as there may be a risk of
fire or explosion.
Check the power cord regularly for visible damage. If the cord is
damaged, it must be replaced by the official Technical Support
Service of Cecotec in order to avoid any type of danger.
Use the product in a well-ventilated area.
The device will reach high temperatures during use. To
avoid burns, do not let bare skin touch a hot surface.
Keep combustible materials, such as furniture, pillows, bedding,
paper, clothes, and curtains at least 1.5 m from all sides of the
heater. Avoid exposure to direct sunlight.
Do not place the appliance close to heat sources, flammable
substances, wet surfaces where it can fall or be pushed into
water or allow it to come into contact with water or other
liquids.
To prevent a possible fire, do not block air intake or exhaust in
TOTALPURE 3IN1 VISION
7