Cleaning And Maintenance - cecotec TOTALPURE 3IN1 VISION Bedienungsanleitung

ENGLISH
and the fan will stop oscillating.
Heat mode
Press the Heat mode button on the remote control or set it on the main panel, the display will
show the room temperature.
Use the "+" and "-" buttons on the remote control to set the desired temperature from 1 ºC to
30 ºC. The temperature digits will blink.
Note: The set temperature should be higher than the room temperature one in order for the
Heat mode to operate properly.
Once the set temperature has been reached, the Heat mode will turn off and the device will
switch to a cool breeze.
If the room temperature falls below the set temperature, the Heat mode will be automatically
activated again.
The maximum operating time of the Heat mode is 9 hours. After this time, the device will
automatically turn off. To restart it, press the power button or use the remote control.
Note:
The default operating temperature is 25 ºC.
The device panel does not display temperature values below 0 ºC. If the room temperature is
lower than 0 ºC, the display will show 01.
Safety system
This product features an overheat protection sensor and a tip-over safety feature that cuts
power to the unit if it is accidentally tipped over or in case of overheating. If this sensor
is triggered, unplug the machine and allow the fan to cool down. Check and remove any
obstructions before restarting the device and be sure to place it on a hard, stable surface.

4. CLEANING AND MAINTENANCE

Turn off and unplug the device from the power supply before cleaning or storing it.
Do not wet or allow water to come inside the device.
Use a soft, damp cloth to clean the device's surface. If a deeper cleaning is required, dilute
mild detergent in water and wipe it with a soft cloth.
Do not use chemical or harsh abrasive cleaning agents.
Air inlet/outlet
Use a soft brush or a vacuum cleaner to clean the dust in the air inlet and outlet. Clean it
TOTALPURE 3IN1 VISION
31