Manual Operation; Remote Control - Knsing Ef455Sl-E Aufbau- Und Bedienungsanleitung

- Temperature / timer selection: This usually shows the room temperature. The selected temperature
is shown while you are selecting the temperature setting. The selected timer setting is shown while
you are setting up the timer.
- Time / temperature: Normally, the current time is displayed. The selected time is shown while you
are setting up the timer. The selected temperature is displayed while you are setting the tempera-
ture for the weekly timer.
- Timer starting time and timer end time: These are shown while you are setting the timer. They are
used in combination with the selected timer setting.
- Flame brightness: Displays the current brightness of the flame (5 levels).

Manual operation

The switch is located on the top right-hand side of the device. The sleep mode flip switch must be
turned on first. The device will beep to indicate that it has been turned on.
Press the "I/O" button once, to turn on the device and flame effect. A red control light will show that the
flame effect has been turned on.
Press the "I/O" button for 3 seconds, to activate the dimmer mode. Hold the button until the desired
brightness is reached.
Press the 900W button once for the low heating setting. Press it twice to turn it off.
Press the 1800W button once for the high heating setting. Press it twice to turn it off.

Remote control

The switch is located on the top right-hand side of the device. The sleep mode flip switch must be
turned on first. The device will beep to indicate that it has been turned on.
It takes a few seconds, before the receiver will react to the sender. Do not press the keys more than
once within two seconds.
Booting process
1. Connect the device to the power supply.
2. Turn the power switch to on.
3. Press the "ON/OFF" key on the remote control to start the device.
4. Press the 900W button once for the low heating setting. Press it twice to turn it off.
5. Press the 1800W button for the high heating setting. Press it twice to turn it off.
6. Press the "DIMMER" button, to operate the dimmer mode.
Automatic heating function
Press the "IC" key on the remote control to start or stop the automatic heating function.
After the device is switched on, it can adjust the heating mode automatically, depending on the speci-
fied temperature and the room temperature. The heater may be started earlier, while a time-controlled
start process is activated.
Specifying the day and time
1. Settings are entered using the remote control.
2. Press the "DATE/TIME" key, followed by "▲" or "▼", to select the day.
3. Press the "DATE/TIME" key again, followed by "+" or "-", to specify the hours.
4. Press the "DATE/TIME" key again, followed by "+" or "-", to specify the minutes.
5. Press the "OK" key to finish the process.
- 26 -