Huawei WATCH Kurzanleitung Seite 7

Statement
Hereby, Huawei declares that this device CP81-1 is in compliance
with the essential requirements and other relevant provisions of
Directive 2014/53/EU.
The most recent and valid version of the Declaration of
Conformity (DoC) can be viewed at
http://consumer.huawei.com/certification.
This device may be operated in all member states of the EU.
Observe national and local regulations where the device is used.
This device may be restricted for use, depending on the local
network.
Frequency Bands and Power
(a) Frequency bands 110.5–148 kHz.
(b) Maximum radio-frequency power transmitted in the
frequency bands in which the radio equipment operates: The
maximum power for all bands is less than the highest limit value
specified in the related Harmonized Standard.
The frequency bands and transmitting power (radiated and/or
conducted) nominal limits applicable to this radio equipment are
as follows: 25.43 dBμA/m at 3 m.
Accessories and Software Information
The product software version is 88.65.10.80. Software updates may
be released by the manufacturer to fix bugs or enhance functions
after the product has been released. All software versions released
by the manufacturer have been verified and are still compliant with
the related rules.
All RF parameters (for example, frequency range and output power)
are not accessible to the user, and cannot be changed by the user.
For the most recent information about accessories and software,
see the DoC at http://consumer.huawei.com/certification.
FCC Statement
When the device is running, keep a minimum distance of 15 cm
away from it. This device has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This device generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this device does cause harmful interference to radio
or television reception, which can be determined by turning the
device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the device and receiver.
--Connect the device into an outlet on a circuit different from that
to which the receiver is connected.
3