Karomat 66608 Gebrauchsanleitung Seite 34

5. Apply detergent so it thoroughly covers cleaning surface. Apply from bottom
to top to prevent detergent from sliding down and streaking.
6. Allow detergent to remain on the surface for a few minutes. This is a good
time to use a brush to lightly scrub heavily soiled areas. Never allow
detergent to dry on the cleaning surface.
7. Remove detergent applicator from gun and replace with the lance, or remove
applicator from end of lance.
8. Rinse detergent from surface.
NOTE: Flush detergent applicator with clear water following each use.
4 Final Rinse
Start final rinse at bottom an work upward. Make sure you thoroughly rinse the
surface and that all detergent has been removed.
5. Shut down
1) Be sure all detergent is flushed from system.
2) Turn off motor.
3) Turn off water supply.
4) After motor and water supply are turned off, trigger gun to depressurize
system.
CAUTION: NEVER turn water supply off before turning motor off. Serious
damage could occur to the pump and/or motor.
WARNING! NEVER disconnect high pressure discharge hose from machine
while system is pressurized. To depressurize, turn motor off, turn water supply
off and squeeze gun trigger 2-3 times.
After each use, wipe all surfaces of the pressure washer with a clean, damp
cloth.
Storage
Do not store pressure washer outdoors.
Do not store pressure washer where it might freeze.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE WASHER
- Never operate unit without water.
- The machine has the possibility to work with warm water. However, the water
temperature may never exceed 50ºC, because this will significantly reduce
the life of the pump.
- Using detergent other than another brand may cause damage to pump
components (o-rings, etc.).This also applies to chemicals such as bleach,
dish soap, etc.
- Never operate unit for more than one (1) minute without spraying water.
Resulting heat buildup will damage pump.
32