Braun 5 Serie Bedienungsanleitung Seite 27

For your shaver a variety of attachments are
available. Which ones are included depend on
your model purchased.
To exchange the attachments just take off the
one that is currently attached by lifting it from
the back to the front as shown in the pictures.
Then just click the new attachment on your
shaver by holding it at the sides and pushing it
downwards (direction doesn't matter).
Precision trimmer 02-PT
02 - PT
To trim contours, sideburns, moustache or
beard: Move it against the direction of your
beard growth.
Beard trimmer 05-BT
05 - BT
with combs (1/2/3/5/7 mm)
To trim contours, sideburns, moustache or
beard: For shortening to different lengths, just
slide the comb attachment onto the beard
trimmer until it clicks into place. Move it
against the direction of your beard growth.
Body trimmer 06-BDT
06 - BDT
with combs (sensitive 1mm / 3mm)
To trim body hair. For delicate areas only use
with comb attached.
3-day beard trimmer 08-3DBT
08 - 3DBT
with 4 x 2 combs (0,5 – 2,3 mm)
To trim your beard to an even 3-day beard
look. Several comb attachments are available
for certain length trimming. Please always
click on a pair of the same length.
This attachment cannot be used to shorten
very long beards. Those would need to be
pre-cut with the precision or the beard
trimmer.
Facial cleansing brush 03-BR
03 - BR
with protective cap
Moisten your skin and the brush head lightly
with water. You may use the facial brush as
part of your daily cleansing routine: with soap,
cleanser, cleansing milk, gel or simply with
water.
Turn on the appliance. Guide the brush with
gentle pressure and circular motions. Avoid
the eye area and hairline.
The brush can be rinsed with cold water. If you
prefer cleaning it thoroughly with soap, you
may detach the brush. After cleaning, leave all
parts to dry completely before reattaching.
For best results, replace the brush unit (BR-R)
every 6 months or sooner if bristles become
deformed due to frequent usage.
Cleaning of Foil & Cutter
cassette / trimmer attachment
Cleaning under running water
Especially important after foam or gel usagel
Switch on the shaver cordless and rinse the
Foil & Cutter cassette / trimmer attachment
under hot running water until all residues have
been removed. You may use liquid soap
without abrasive substances. Rinse off all
foam and let the shaver run for a few more
seconds.
Next, switch off the shaver, remove the Foil &
Cutter cassette / the trimmer attachment and
let it dry.
If you regularly clean the shaver under water,
apply a drop of light machine oil on top of the
Foil & Cutter cassette / the trimmers once a
week.
27