BEARWARE 303287 Bedienungsanleitung Seite 15

9. Switching on and off manually
You can manually switch on and switch off the device connected to the timer
using the "MANUAL" button, or enable the automatic control according to the
configured timer programmes again.
Press the "MANUAL" button briefly to change between the different modes. The
display changes between "AUTO", "ON" and "OFF".
"AUTO" means that the timer switches on and off automatically within the
enabled timer programs.
When "ON", the timer continuously supplies power to the connected device.
When "OFF", the timer does not supply power to the connected device.
Note: Please note that when changing from "ON" or "OFF" to "AUTO", the last
timer state is retained until one of the configured timer programmes triggers a
change.
10. Random function
The random function allows you to set random switch-on and switch-off times
for the timer between 10 and 31 minutes in the time period from 6 pm to 6 am.
Press the "RND" button to enable or disable the random function. When the
function is enabled, this is indicated by the symbol "R" in the display.
11. Countdown function
Press the " Minus" button in time display mode to access the countdown func-
tion settings. Press the "SET" button to configure the settings. Enter the desired
settings using the "PROG/+" and "Minus" buttons.
During the countdown, select whether the timer should supply power and switch
off at the end of the countdown using the "ON" function. Alternatively, the timer
can be set using the "OFF" function so that the power is switched on only at the
end of the countdown.
Confirm your selection with the "SET" button and then select the desired hours,
minutes, and seconds, which also have to be confirmed using the "SET" button.
Note: Please remember that the random function has to be disabled and the
device has to be in "AUTO" mode.
15
English