BEARWARE 303287 Bedienungsanleitung Seite 14

8. Setting the timer programmes
Briefly press the "PROG/+" button while you are in time display mode. The pro-
gram menu is displayed. Then select a program (1-10). You can move between the
individual switching on and off points using the "PROG/+" button and the "minus"
button and select the desired switching point, which can be edited by pressing
the "SET" button.
With the "PROG/+" button and the "Minus" button, it is possible to select the
days of the week desired for the switching point and to confirm these using the
"SET" button. Then select the desired time for the switching point via the same
step and confirm it again using the "SET" button. Then you can again select the
other switching points using the "PROG/+" button and the "Minus" button and
configure the appropriate switch on/off time. Set the time and days of the week
using the "SET", "PROG/+" and "-" buttons as described in the previous step.
Note: Please remember that the days of the week for switching on and switching
off have to be configured separately. The selected combination is not automatical-
ly adopted for the entire timer programme.
A total of 10 timer programmes are available, all of which you can configure in
this way. Once all the programs have been customised to your requirements,
please press the "PROG/+" and "Minus" button simultaneously to display the
time again. The display again shows the current time and the day of the week.
The timer is now ready for use.
Note: Please ensure that the times of the individual timer programmes do not over-
lap in order to avoid unintentional switching on or off.
To disable a timer programme or to enable a disabled program again, press the
"PROG/+" button until the desired program is shown in the display. You can now
enable or disable the timer programme using the "MANUAL" button.
14
English