Programming The Appliance - Brita Flowmeter 100-700A Handbuch

4.2 Programming the Appliance

PROG
"BATT" flashes when
the battery has run out
4.2.1 Programming the Litre Information
• Briefly press the "PROG" button
"PRG" flashes in the display
filter system manual.)
Note: Press the "PROG" button
changes.
• Press the "RESET" button
flashes in the display
• Press the "RESET" button
display .
8
• Press the "PROG" button
flashes.
• Repeat the steps above until the litre information determined has been entered.
• Press the "PROG" button
programming mode. The "PRG" field in the display
• The litre information entered is shown in the display
missioned.
4.3 Installation of the Sensor
Note: During installation, pay attention to the direction of flow.
• Close the water inlet.
• If a filter system is already installed, remove the inlet hose
nut.
• Tighten the union nut
seal .
6
• Tighten the inlet hose
Caution: The max. tightening torque at the 3/4" connections must not exceed
!
15 Nm!
4.4 Installation of the Display Unit
The display unit can be attached to the desired position with double-sided adhesive tape
or a screw (neither included in the delivery scope).
Caution: There must not be any water pipes or electrical cables behind the mounting
!
surface. Do not lay the connecting cable parallel to cables conducting electricity because
this can lead to an impairment of the sensor signal.
10
RESET PROG
"PRG" flashes when the
programming mode is
activated
, the display changes to the programming mode,
7
. (How to identify the filter capacity is described in the
8
again to leave programming without making any
7
to jump to the litre information. The relevant number
9
.
8
until the desired number is shown flashing in the
9
to reach the next digit to be entered. The relevant digit
7
to confirm the litre information entered and to leave the
7
of the sensor
5
on the sensor
4
RESET
"1,2,3,4,5" flashes during
"Memory Call-Up" and
represents the memory level
no longer flashes.
8
, the system can now be com-
8
on the filter head. If necessary, insert a flat
1
.
2
PROG RESET
that is being called up
by loosening the union
4