Adjustment Of End Switches; Adjustment Of End Switch "Closed - belfox Jupiter 250 Montageanleitung

17. Adjustment of end switches

Remove the operator from the sheathing of the pile and the sheathing of the
gate wing and fix it once again with the rear side pointing to "the top ". This
makes it easier to adjust the end switches.

17.1 Adjustment of end switch "CLOSED "

Using the clamp attach the connecting cable to the 3 V button cell included
in the delivery. This makes the LED of the end switch "CLOSED "flash.
Now remove the locking screw of the end switch " CLOSED " (see page 19 ,
point 17.2 "Altering the position of end switches") and move it towards the
crankcase until the LED of the end switch "CLOSED" ceases to flash. Now
the end switch "CLOSED" has reached the correct position.
18