Control - Menus; Home Screens - Nibe RMU S40 Installateurhandbuch

HEAT
Climate system 1
Menu symbol
Current temperature
Set temperature
Works to set temperature
Press the card to adjust the desired value. On certain
function pages, drag your finger up or down to obtain
more cards.
MENU TREE
In the menu tree, you can find all menus and can make
more advanced settings.
HEAT
Climate system 1
You can always press "X" to return to the home screens.
24
Menu tree
Board
Control – Menus

HOME SCREENS

HEATING AND COOLING
You make temperature settings for your installation here.
If the climate system in the house has several zones for
heating or cooling, this is shown on the display by a
function page for each zone.
Setting the temperature (without controlling room
sensor activated):
Setting range: -10 – 10
The display shows the set value for heating/cooling
(curve offset). To increase or reduce the indoor temper-
ature, increase or reduce the value in the display.
The number of steps the value has to be changed in
order to achieve a one degree change to the indoor
temperature depends on the climate system. One step
is usually enough, but in some cases several steps may
be required.
Setting the desired value. The new value is shown on
the right-hand side of the symbol on home screen
cooling.
Setting the temperature (with controlling room
sensor activated):
Heating
Setting range: 5 – 30 °C
Cooling
Setting range: 5 – 35°C
The value in the display appears as a temperature in °C,
if the zone is controlled by a room sensor.
Caution
A slow climate system, such as underfloor
heating, may be unsuitable for controlling with
room sensors.
Caution
An increase in the room temperature can be
slowed by the thermostats for the radiators or
under floor heating. Therefore, open the ther-
mostats fully, except in those rooms where a
cooler temperature is required, e.g. bedrooms.
NIBE RMU S40 | GB