Maintenance And Care - LEXIN LX-FT4 Pro Bedienungsanleitung

Additional Notes for Intercom connections:
Bridge Units:
- Bridge units connect with other bridge units with the B Button and will flash purple when they are
connected.
- Bridge units connect with non-bridge units with the A Button.
- Devices are connected like a chain. To maximize communication range, keep the units in the order
the links are connected.
- The Bridge unit cannot be connected with a Bluetooth device (phone or GPS) while it is being used
as an Intercom Bridge.
Enabling Intercom Talk:
- You will hear a beep sound when you start an intercom talk.
- It may take a few seconds to connect the other units, please wait until both units are connected to
talk.
Device Range:
- If one intercom rider goes out of range during an intercom talk, there may be static and eventually
the intercom will disconnect. In this case, the Lexin FT4 Pro automatically tries to reconnect the
intercom rider every eight seconds and you will hear high tone double beep until the connection is
re-established.
Auto-connect: To disable auto connect, press the Jog Dial button.
Battery Conservation: To save battery power, disconnect the intercom units if you do not need to
talk.

Maintenance and Care:

Follow the suggestions below for optimal care of your Lexin FT4 Pro device and to maintain
warranty protection.
- Do not use or store the device in dusty or dirty environments. Moving parts and electronic
components can be damaged.
- Do not store the device in high heat areas. High temperatures can shorten the life of electronic
devices, damage batteries, and warp or melt certain plastics.
- Do not store the device in cold temperature areas. When the device returns to its normal
temperature, moisture can form inside the device and damage electronic circuit boards.
- Do not attempt to open the Lexin FT4 Pro case.
- Do not drop or knock the device. Rough handling can break internal circuit boards and fine
mechanics.
- Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.
- Do not paint the device. Paint can clog the moving parts and prevent proper operation. These
suggestions apply equally to the headset main unit, speaker-microphone clamp unit, and power
charger.
12