LEXIN LX-FT4 Pro Bedienungsanleitung Seite 13

Note: Before pairing decide which units will be unit one, unit two aka the first bridge unit, unit three
aka the second bridge unit, and unit four. It is best to designate these in the order riders will be
riding to increase range.
Step 1 Pairing unit one with
unit two - first bridge:
- Power off both units.
- Press and hold the A Button
on both devices.
- LED of both units will flash
red and blue when they enter
pairing mode.
- Click the A Button on either
unit to pair. Once pairing starts,
the LED on the unit clicked will
flash only blue.
- When pairing is complete, the
LED will blink blue on both
units.
Step 4 Enable intercom talk:
Connect unit one with unit
two-first bridge:
- Click the A Button on unit
two or unit one.
- The LED will flash 3 times in
blue every 3 seconds on both
units indicating they are
connected.
Connect unit three-second
bridge with unit four:
- Click the A Button on either
unit three or four.
- The LED will flash 3 times in
blue every 3 seconds on both
units indicating they are
connected.
Connect unit two-first bridge to
unit three-second bridge:
- Click the B Button on either
unit two or unit three to
connect.
- The LED will flash 3 times in
purple every 3 seconds on both
units indicating they are
connected.
Four Devices:
Step 2 Pairing unit three -
second bridge, with unit
four:
- Power off both units.
- Press and hold the A Button
on both devices.
- LED of both units will flash
red and blue when they enter
pairing mode.
- Click the A Button on either
unit to pair. Once pairing
starts, the LED on the unit
clicked will flash only blue.
- When pairing is complete,
the LED will blink blue on
both units.
Step 5 Disable intercom
talk:
Disconnect unit one from
two-first bridge:
- Click the A Button or Jog
Dial button on unit one or unit
two.
- The other three units will
stay connected.
Disconnect unit three and unit
four only:
- Click the A Button or Jog
Dial on unit four or unit three.
- The other three units will
stay connected.
Disconnect unit two and unit
three only:
- Click the B Button on either
unit three or unit four.
- Unit two will remain
connected to unit one.
- Unit three will remain
connected to unit four.
- Unit one and unit four will
no longer be connected.
Disconnect all units:
- Click Jog Dial on both unit
two and unit three.
11
Step 3 Pairing unit two - first
bridge, with unit three - second
bridge:
-Ensure both devices are
powered on.
- Press and hold the B Button on
unit two and unit three.
- The LED of both units will
flash red and blue when they
enter pairing mode.
- Click the B Button on either
unit to pair. Once pairing starts,
the LED on the unit clicked with
flash only blue.
- When pairing is complete, the
LED will blink blue on both
units.