LEXIN LX-FT4 Pro Bedienungsanleitung Seite 12

Note: Before pairing decide which units will be unit one, unit two aka the bridge unit, and unit three.
It is best to designate these in the order riders will be riding to increase range.
Step 1 Pairing unit one with unit two -
becomes bridge unit:
- Power off both units.
- Press and hold the A Button on both devices.
- LED of both units will flash red and blue
when they enter pairing mode.
- Click the A Button on either unit to pair.
Once pairing starts, the LED on the unit
clicked will flash only blue.
- When pairing is complete, LED will blink
blue on both units.
Step 3 Enable intercom talk:
Connect unit one with unit two-bridge:
- Click the A Button on unit two or unit one.
- The LED will flash 3 times in blue every 3
seconds on both units indicating they are
connected.
Connect unit two-bridge to unit three
- Click the B Button on either unit two or unit
three to connect.
- The LED will flash 3 times in blue every 3
seconds on unit three and purple on unit two
indicating they are connected.
Note: The LED light on unit two-bridge unit will flash in purple indicating three units are connected.
Three Devices:
Step 2 Pairing unit two-bridge, with unit
three:
- Ensure both devices are powered on.
- Press and hold the B Button on unit two and
unit three.
- LED of both units will flash red and blue
when they enter pairing mode.
- Click the B Button on either unit to pair.
Once pairing starts, the LED on the unit
clicked with flash only blue.
- When pairing is complete, LED will blink
blue on both units.
Step 4 Disable intercom talk:
Disconnect unit one from unit two only:
- Click the A Button or Jog Dial button on
unit one or unit two.
- Unit two and unit three will stay connected.
Disconnect unit two from unit three only:
- Click the B Button on either unit three or.
- Unit one and unit two will stay connected.
Disconnect all units:
- Click Jog Dial on unit two.
10