Schwaiger UFB 106 Bedienungsanleitung Seite 9

If you notice the reaction of your device too late and the next code has already been
emitted you can go back by pressing CHAN- (21). If your device was switched off, you
must turn it on again. Turn your device on pressing its own "Power" button, or with its
original remote control, to continue the search.
•
To test whether the right setting has been found, simply press a few
buttons on the UFB106/16 and check whether the functions work correctly.
If everything is OK you can now set the UFB106/16 for the second device.
If nothing happens or some of the buttons do not work correctly you need
to continue to search for the correct setting. The UFB106/16 continues the
search at the point you stopped with the OK (23) button. When the end of
the code list is reached the search stops automatically and the remote
control blinks quickly several times. The code last confirmed prior to
searching remains stored.
Quick Code Search
Your remote control finds the correct settings almost automatically in seconds:
•
Switch on the device to be controlled with its own Power button.
•
Keep the SETUP button (4) pressed until the LED lights constantly.
•
Press the required device button, e.g. DVD.
•
Press the POWER (1) button once briefly.
The UFB106/16 automatically sends a different IR code once per second. When your
device reacts, immediately press the OK button (23) to confirm the code. We advise
you to place your finger over the OK button (23) so that you can react quickly enough.
Otherwise the UFB106/16 transmits the next signal before you have reacted.
Note: With very few devices the quick search does not work. The search is
automatically stopped if there is no reaction from the device to be controlled. You
should then use a different setting procedure, e.g. code entry or slow search.
Instead of pressing OK and missing the correct code you can also switch the
UFB106/16 to slow code search by pressing the CHAN+ (21) or POWER (1) button.
Remember to switch on your device again, e.g. DVD, if you wish to continue the
search.
•
Finally, test the set code by controlling e.g. your DVD device. If it does not
work correctly, please start the code search again. The code search then
starts with the next code in the sequence.
Searching by Brand
You can considerably speed up the code search if you search by brand. This is done
as follows:
•
Switch on the device to be controlled with its own Power button.
•
Keep the SETUP button (4) pressed until the LED lights constantly.
•
Press the required device button, e.g. TV.
•
Press the brand number button
•
Press the POWER or CHAN+ buttons and continue as described in Slow
Code Search above.
Code Identification
You can identify the codes found at any time:
•
Keep the SETUP button (4) pressed until the LED lights constantly.
•
Press the required device button, e.g. DVD.
•
Press the SETUP button (4) again briefly.
•
To identify the 4-digit code, press the number buttons, 0-9, one after the
other. The thousand figure is displayed when the light goes out briefly
when a button is pressed. The number corresponds to the button number.
The hundred figure is displayed when the light goes out briefly when a
button is pressed a second time. The number corresponds to the button
number. The ten figure is displayed when the light goes out briefly when a
button is pressed a third time. The number corresponds to the button
number. The one figure is displayed when the light goes out when a button
is pressed a fourth time. The number corresponds to the button number.
1 Philips
2 Sony, Panasonic, JVC,
Toshiba
3 Thomson
4 Telefunken
5 Grundig
6 Nokia
0 All other Brands
10