Troubleshooting; Other Information; Warranty - Zanussi EMZ17-SSB Gebrauchsanweisung

TROUBLESHOOTING

ISSUES
THE DEVICE DOES NOT
WORK, NO BUTTONS
LIGHT UP.
WATER LEAKING
THE STEAM NOZZLE IS
NOT WORKING.
THE COFFEE
OVERFLOWS THE
FILTER HOLDER.
THE COFFEE IS NOT
HOT ENOUGH.

OTHER INFORMATION

Technical information
MODEL
POWER SUPPLY
POWER
PUMP PRESSURE
WATER TANK MAX CAPACITY

WARRANTY

The warranty of the product does not cover any use
that breaches the product instructions for use:
- an installation that does not comply with legal
and regulatory provisions (not having an earth
36
CAUSES
1. The appliance is not
plugged in.
2. The appliance is in standby
mode.
1. The water tank is
incorrectly inserted.
2. The drip tray is full.
3. The filter holder is
incorrectly locked.
1. No water in the water tank.
2. The steam nozzle is
obstructed.
1. The filter holder is not
properly locked.
2. The coffee grounds are too
fine.
3. The filter's seal is defective.
1. The machine is cold.
2. The cup is cold.
3. Build-up of limescale in the
device.
SPECIFICATIONS
EMZ17-SSB
220-240V~ 50-60Hz
1100W
20 bars
1.2 L
www.zanussismallappliances.nl www.zanussismallappliances.be www.zanussismallappliances.fr
SOLUTIONS
1. Check whether the device is connected to
power supply.
2. Press the ON/OFF button to exit standby
mode.
1. Lift up the water tank and make sure you
put it back.
2. Empty the used water from the drip tray.
3. Remove the filter holder, check the coffee
level and replace the filter holder.
1. Fill the water tank.
2. Proceed to clean the steam nozzle.
1. Remove the filter holder, check the coffee
level and replace the filter holder.
2. Use a thicker coffee grind.
3. Contact the after-sales service.
1. Start a large cup cycle with an empty
adapter to warm the internal circuits of the
appliance.
2. Preheat the cup.
3. Descale the appliance.
connection, moving the appliance during use
leading to a cut in the power cord or the supply
and drainage pipe, or subsequent to external
phenomena, such as lightning, flooding, and more