Connecting The Speaker Output Terminals; Secure The Optical Cable - Pioneer RS-A7 Bedienungsanleitung

Connecting the Units
Connecting the Speaker Output
Terminals
1. Expose the end of the speaker wires
using nippers or a cutter by about
10 mm and twist.
2. Attach lugs to speaker wire ends.
Lugs not supplied.
• Use pliers, etc., to crimp lugs to wires.
3. Connect the speaker wires to the
speaker output terminals.
• Fix the speaker wires securely with the termi-
nal screws.
Terminal screw
Speaker output terminal
15
Twist
10 mm
Lug
Speaker wire
Speaker wire

Secure the optical cable

Secure the optical cable using the sup-
plied clamp as shown below.
• When the optical cable is routed
under the board.
Optical cable
Clamp
• When the optical cable is routed
on the board.
Clamp
Optical cable
This unit
This unit