Rossler R705 Magnetic Gebrauchsanweisung Seite 59

1
2
13
3
36
37
4
38
16
39
72
3-B
3pc s 3pc s 3
6. METER POST
11
3-A
80
pcs
First please remove the three M8*20
inner hexagon screws (38), three M8
spring washers (37) and three
OD20*ID8.5T*1.5T (36) arc washers
which are pre-assembled on the meter
post (13) with the 5MM INNER
SPANNER
Turn the level of TCD on the meter
post (13) at the lowest status, under
this circumstance, the wire will come
out longest.
Move the meter post lower housing (39) up a
little bit.
Take the meter post (13) close to the
lower. Connect the sensor wire upper
section (11) with the lower section (80);
connect the TCD upper segment (16)
with the lower segment (72). (3-B)
Insert the meter post into the lower
one. Use the removed screws and
washers to lock them according to the
drawing left. Release the housing (39)
and fix it onto the cover.
59