Maintenance And Cleaning - KIKKA BOO AMICA Gebrauchsanweisung

WARNINGS
1. Read these instructions carefully before use and keep them for future reference. Your child' s safety may be a ected if you do not follow
them.
2. This stroller is suitable for children from newborn to 36 months and weight up to 15 kg!
3. Ensure that the seat attachment and bumper bar are locked before moving the stroller from a stationary position and keep these
locked at all times when travelling with a child.
4. Ensure the brake is engaged when loading and unloading the child.
5. Any load attached to the handle a ects the stabillity of the stroller and may cause the stroller to tip backwards and cause serious
injury to the child.
6. Never leave your child unattended!
7. Do not add a mattress thicker than 10 mm.
8. Always use the restraint system! Always use the crotch belt in combination with the waist belt.
9. Please do not attempt to fold the stroller if the child is in the seat or the carrycot.
10. Always engage the brake when you remove your hands from the handle and ensure that the stroller does not tip backwards.
11. This product is not suitable for running or skating.
PARTS
1. Canopy 2. Bumper bar 3. Harness 4. Basket 5. Front wheel components 6. Seat' s angle adjusting system 7. Folding mechanism
8. Folding Lock
INSTALLATION AND OPERATING INSTRUCTIONS
1-2. OPENING THE STROLLER FRAME: Unhook the folding latch, uplift the handle bar until the frame clicks into position.
3. ATTACHING THE FRONT WHEEL: Insert the front wheels set to the front section of the frame. The wheel can be set to lock, to stop the
swivel movement. To engage the swivel lock, push down the lever between the wheels.
4. ATTACHING THE REAR WHEELS: Lift up the rear axle and put the rear wheels onto the axle, making sure they are locked into position.
5. ENGAGING THE BRAKES: Step on the rear part of the brake stop. To release the brake, step on the front part.
6. BUMPER BAR INSTALLATION: Click the locks on the bumper bar into the plastic housing and make sure it is tightly lockes into position.
7. ATTACHING THE FOOTMUFF: Locate the straps on the top of the footmu and strap these around the bumper bar as shown in gure 7a
and 7b. Then locate the straps to the side of the aluminium seat frame, see gure 7c and 7d.
8. ASSEMBLING THE SEAT: Align the seat above the upright tubes and push down, making sure the seat locks onto both tubes. To remove
the seat attachment, press the button on each of the upright tubes and lift the seat attachment.
9. SAFETY BELT RELEASE: Press down the button on the buckle and pull latches to release them.
10. SAFETY BELT FASTEN: Insert the two latches into buckle on both sides until they lock with a click. Sliding lenght adjusters are tted
and should be carefully adjusted on each side so the harness ts on each side so the harness ts your child comfortably. D rings are tted
at the end of each waist strap, should you wish to attach a separate harness for additional safety.
11. CANOPY INSTALLATION AND USE: Put the canopy buckles around the upper section of the stroller frame. The canopy can be
extended/retracted to the desired position.
12. BACKREST ADJUSTMENT: Press and hold the button on the top of the seat and rotate the seat to adjust the recline position.
13. FOLDING: Press up and holg the lock on the inside right side of the tube, and gently push down on the frame until the frame is in
locked position. Press the button on each side of the handle bar and pull down the handle to make the stroller more compact when
folded.

MAINTENANCE AND CLEANING

1. To ensure your child' s safety please check the safety features of your stroller periodically and keep it maintained to a good standard.
2. Please use a brush to clean the fabrics and do not use strong detergents or abrasive cleaning materials to clean it.
3. Run regular checks for loose or damaged parts and if there are such, immediately replace them with new ones.
4. Always operate or assemble the stroller according to this instructions manual.
ENGLISH