Care And Cleaning - KIKKA BOO AMAIA Gebrauchsanweisung

V. INSTALL THE REAR WHEELS
Lift the rear frame up and fully insert the rear wheel into the mounting hole at the side of the frame. Repeat the step for the other rear
wheel (Figure 1.2). Before usage, please pull the rear wheels outward to check whether they are properly installed.
VI. INSTALL THE SLEEPING BASKET: Insert both ends of the sleeping basket to the frame until hearing a "click" sound.
VII. INSTALL THE ARMREST: Insert both ends of the armrest to the sleeping basket until hearing a "click" sound.
VIII. INSTALL THE CANOPY: Zip up the zippers on both the canopy and the sleeping basket.Install both ends of the canopy to sleeping
basket. Follow gures from 1 to 4.
FEATURES
IX. ADJUST THE CANOPY : The canopy can be folded or open directly by pulling.
X. FRONT WHEEL ORIENTATION: Lift up the paddle ( shown in the pic) to orient the front wheels, and push it down to release the
orientation.
XI. REAR WHEEL BRAKE: Step the brake bar downward and the wheels will be braked. Lift the brake bar upward to release the brake.
XII. ADJUST THE BACKREST: Use the adjusting belt behind the backrest to adjust it to lying or sitting position.
XIII. ADJUST THE FOOTREST: Buckle the belts under the sleeping basket can adjust the position of the footrest.
XIV. ADJUST THE POSITION OF THE SLEEPING BASKET: Press down the two buttons on both sides of the sleeping basket can adjust it' s
position. The sleeping basket can be adjusted to three di erent angles. Follow gures from 1 to 3.
XV. REVERSE THE SLEEPING BASKET :Grab up the two buttons as shown in the picture to remove the sleeping basket. Turn the sleeping
basket to the other side and re-install it. Follow gures from 1 to 4.
XVI. FOLDING: Remove the sleeping basket rst. Pull up the folding bar on both sides as shown in the pic, and push the handle
downward. Lock the frame. Follow gures from 1 to 4.
XVII USAGE OF SAFETY BELTS: We apply the ve-points safety belt, ensuring the baby' s safety. The belts can be adjusted according to the
baby' s need.
Press the red button to release the safety belt.
XVIII. CARE AND CLEANING
Fabric parts:
The fabrics of the product must be cleaned with warm water and mild soap.
Plastic and metal parts:
1. The plastic and metal parts must be cleaned with a damp soft cloth and dried with dry soft cloth.
2. Do not let the product exposed to the harmful effect of external factors - direct sunlight, rain, snow or wind. This may lead to damage
of the metal and plastic parts and fading of the fabrics of the crib.
3. When you are not using the product, store it at a dry and well ventilated place, not in dusty, humid premises with very high or very low
room temperatures.
Frame: From time to time check all plastic parts that are hanged on the frame. Tighten all screw and bolts if necessary.
ENGLISH