Operator Training; Personal Protective Equipment (Ppe); Warnings And Notes; Product Symbols - Cleco CellCore 200 Serie Handbuch

2
EN

2.4 Operator Training

The tightening system may only be put into operation,
adjusted and tested by qualified and trained personnel.
The personnel must be instructed by qualified employees
of Apex Tool Group GmbH/Apex Tool Group‚ LLC.
The controller has been preset by Apex Tool Group GmbH.
Any adjustment of the controller to accommodate special
requirements may only be carried out by a qualified per-
1)
son .
Additional information can be found in the Programming
Manual.
2.5 Personal Protective Equipment
(PPE)
Risk of injury by being wound up in and caught by machin-
ery
 When working with rotating parts, it is not permitted to
wear gloves.
 Recommendation: Freely rotating u-GUARD pro-
tected fastening tools from APEX.
 Wear close-fitting clothing.
 Wear safety shoes.
 If necessary, wear a hairnet.
Risk of injury due to parts being ejected:
 Wear protective goggles.

2.6 Warnings and notes

Warning notes are identified by a signal word and a picto-
gram:
• The signal word describes the severity and the proba-
bility of the impending danger.
• The pictogram describes the type of danger.
Danger
A symbol combined with the word Danger
indicates a hazard with a high level of risk
which, if not avoided, will result in death or
serious injury.
Warning
A symbol combined with the word Warning
indicates a hazard with a medium level of
risk which, if not avoided, could result in
death or serious injury.
Caution
A symbol combined with the word Caution
indicates a hazard with a low level of risk
which, if not avoided, could result in minor or
moderate injuries or environmental dam-
age.
1.) Due to their vocational training, knowledge, experience and
understanding of the circumstances involved in this kind of work,
suitably qualified personnel are able to identify potential hazards
and to initiate appropriate safety measures. Qualified personnel
are obliged to comply with regulations.
14
Note
An symbol combined with the word Note in-
dicates a potentially harmful situation which,
1
if not avoided, could result in damage to the
tool or the environment.
General notes
include application tips and useful infor-
mation but no hazard warnings.

2.7 Product Symbols

Be sure to understand the meaning of each symbol before
operating the controller.
Electrical voltage
CE compliant
The product corresponds to the prescribed
technical requirements in Europe.
Read all instructions.
2019-01
P2403HW |
Apex Tool Group GmbH