Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
Notes on this Description
This description is intended to provide setup and use
instructions for the mPro200GC, mPro200GC-AP,
mPro200GC-G and mPro200GC-AP-G Controllers. Soft-
ware instructions are provided in separate programming
manuals based upon the version installed.
The original language of this document is German.
Minimum Software Requirements
No.
Description
S168813
Standard Controller Software
V1.8.0
S168677
mProRemote – Interface software between
an external computer and controller
Reference Documents
No.
Document type
P1730E
Reference Handbook
Fastening Sequences
P2280PM
Programming Manual
mPro400GC Standard SW
P2402KA
Quick Installation
Instructions WLAN-Data Transfer CellCore
P2398PM
Programming Manual
Cordless Tool CellCore
P3344C
EC Declaration of Conformity mPro200GC
Symbols in the text
Italic
Identifies menu options), input fields, control
boxes, options fields or dropdown menus.
>
Denotes the selection of a menu option from
a menu, e.g. File > Print
<...>
Denotes switches, pushbuttons or keys of an
external keyboard, e.g. <F5>
Courier Denotes filenames and paths, e.g.
setup.exe
•
Denotes lists, level 1
-
Denotes lists, level 2
a)
Denotes options
b)
→
Denotes results
1.
(...)
Denotes action steps in sequence
2.
(...)
Denotes a single action step
Sales &
Cleco Production Tools – Sales & Service
Service
Centers, see last page.
Center
Apex Tool Group GmbH
2
Safety
2.1 General Requirements
Only operate the controller after you have read and
fully understood this document. Failure to follow the
directions and safety instructions could result in elec-
tric shocks, burns and/or serious injuries.
Keep this document in a safe place for future refer-
ence! These safety instructions must be accessible to
the operator at all times. They must be available to all
persons using or repairing the device.
2.2 Intended Use
The product is a part of the Cleco Production Tools Tight-
ening System and is intended exclusively for industrial use
in fastening processes. Only use the controller under the
following conditions:
•
in conjunction with the components listed in the EC
Declaration of Conformity.
•
under the prescribed environmental conditions; see
the relevant documentation
•
with the permissible supply voltage
•
within the power range, which is specified in the tech-
nical data
•
in EMC Limit Class A (electromagnetic immunity for
industrial areas). For the currently observed EMC
standards, see the EC Declaration of Conformity.
2.3 Predictable Misuse
Do not use the controller:
•
in potentially explosive areas
•
in damp spaces/outdoors
•
in connection with cutting tools (drills, milling cutters,
grinders...)
•
in the non-industrial sector (eg residential area)
•
for other drive tasks than screwing with the compo-
nents mentioned in the declaration of conformity.
•
for bridging of safety devices.
2019-01
P2403HW |
2
EN
13
Werbung
Inhaltsverzeichnis
