Setting The Heat Setting; Locking/Unlocking The Control Panel; Using The Automatic Warm-Up Function - AEG 88032K-MN Benutzerinformation

26
Operating the appliance
Switch off
After switching on, within approx. 10 seconds a heat setting or a function must be set,
otherwise the appliance automatically switches itself off.

Setting the heat setting

To set the heat setting
Switch off

Locking/unlocking the control panel

The control panel, with the exception of the "On/Off" sensor field, can be locked at any time
in order to prevent the settings being changed e.g. by wiping over the panel with a cloth.
To switch on
To switch off
When you switch the appliance off, the locking function is automatically switched off.
Turning the STOP+GO function on and off
The STOP+GO function simultaneously toggles all active cooking zones to keep-warm mode
then back to the heat setting they were at before
To switch on
To switch off
STOP+GO does not stop timer functions.
STOP+GO controls the entire control panel apart from the sensor field

Using the automatic warm-up function

All cooking zones are equipped with an automatic warm-up function. When setting a heat
setting using the automatic warm-up function, the cooking zone switches to full power
for a certain amount of time and then automatically switches back to the heat setting set.
Step
1.
Control panel
Touch for 1 second
Touch the desired heat setting,
if necessary, correct to the left
or to the right
Touch 0
Control panel
Touch
Touch
Control panel
Touch
Touch
Control Panel
Touch
Display
/ none
Control Panel
(for 4 seconds)
previously set heat setting
Previous heat setting (not automatic warm-up or power
function)
Pilot light
goes out.
Display
to /
Display
Display
.
Display