BOMANN WA 7182 Bedienungsanleitung, Garantie Seite 28

Detergent dispenser
CAUTION:
The detergent drawer is designed exclusively for the
use of detergents for washing machines!
NOTE:
• Always add the detergent powder just before
starting the wash cycle, otherwise it could get
damp and will not dissolve properly.
• At the end of the wash cycle the drawer must be
empty.
I. Chamber for pre-wash detergent.
II. Chamber for main wash detergent.
Chamber for detergent additive (softener). Do not
exceed the MAX mark!
Control panel
1 Program selector switch
To select a wash program, turn the program selector
switch to the appropriate position. For details about
the programs, see the "Program table".
2 START/PAUSE
Press the button to start/pause the selected or run-
If the device is in pause mode,
ning wash program.
the seconds dot symbol lights up continuously
between hour and minute.
Foam detection
Excessive foam forms when too much detergent is
used. This affects the wash and rinse cycle. The
function automatically checks foaming; excessive
foam is removed by an extra rinse and spin cycle.
Fill in the laundry
• Unravel the clothes before putting them into the
machine.
• Each load should correspond to the nominal ca-
pacity of the appliance. Do not overload the appli-
ance. Different strengths, sizes and types of laun-
dry can affect the actual loading capacity. It is ad-
visable to load the appliance just that a normal
circulation during washing is possible.
• Make sure that no laundries are caught between
the appliance door.
3 TEMP. (Wash temperature)
By repeatedly pressing the button, you select the
required wash temperature.
If the control lamps do not indicate a selection, the
wash temperature remains cold.
4 U/MIN (Spin Speed)
By repeatedly pressing the button, you select the
speed for the spin cycle. If the control lamps do not
indicate a selection, the setting remains 0-spin stop,
there is no spin.
28