Herunterladen Diese Seite drucken

TC Electronic SENTRY NOISE GATE Schnellstartanleitung Seite 4

Vorschau ausblenden Andere Handbücher für SENTRY NOISE GATE:

Werbung

6
SENTRY NOISE GATE
Sterownica
(PL)
USB - Łączy się z komputerem w celu aktualizacji
(1)
oprogramowania sprzętowego i edycji TonePrint.
Gate type selector - Wybiera pomiędzy tradycyjną bramką
(2)
jednopasmową (w górę), niestandardową bramką TonePrint
(w środku) lub wielopasmową bramką twardą, idealnie
dopasowaną do eliminacji syczenia (w dół).
Damp - Reguluje stopień tłumienia sygnału, gdy spadnie
(3)
on poniżej progu.
Send
(4)
Output
(5)
Footswitch - Włącza i wyłącza efekt.
(6)
Power - Podłącz zasilanie 9 V /> 100 mA.
(7)
Threshold - Określa poziom, poniżej którego bramka
(8)
zacznie tłumić sygnał.
Decay - Reguluje szybkość tłumienia sygnału po spadku
(9)
poniżej progu.
Input
(10)
Return
(11)
7
SENTRY NOISE GATE
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
TC Electronic
SENTRY NOISE GATE
Music Tribe Commercial NV Inc.
Responsible Party Name:
5270 Procyon Street,
Address:
Las Vegas NV 89118,
United States
+1 702 800 8290
Phone Number:
SENTRY NOISE GATE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant o part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• •
Reorient or relocate the receiving antenna.
• •
Increase the separation between the equipment and receiver.
• •
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• •
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.

Werbung

loading