Starting The Device; Led Indicators - AVIRE AC-2GM10-100-A-00-000 Installationsanleitung

STARTING THE DEVICE

+
Insert SIM card in connector J2, pressing it until it clicks
+ Ensure that the antenna is screwed in completely in J1 – only use antennas from the
Memco range.
+
Connect the emergency telephone to connector J7 or terminal J8
+
Connect battery to J3
+ Connect 220 VAC power to J5
+ To switch off the device, remove the power supply from J5 and then remove the
battery connection from J3.
DEVICE HEALTH CHECK
See below for an overview of all LEDs. On start-up, you should see the following within
60seconds:
fig 3
RUN LED flashes in green.
BAT LED is always on
SIM LED is green or amber
Coverage LED is green or amber
SLIC LED is green

LED INDICATORS

The Universal Gateway has five indicator LEDs that constantly report
the device status.
Each indicator will be fully on, fully off or flashing. Details of each
indicator and function are detailed below:
fig 4
LED OFF
CRITICAL SYSTEM ERROR
Low battery
Initialising/Missing
sim
Low or no
coverage
Out of service or
initialising
ON
Battery OK
Available GSM/
GPRS
High coverage
Local line ready
Power supply is OK
Battery is OK
Device is connected to the network
Good coverage
Device is in standby
FLASHING
SLOWLY
Proper operation (AC)
or (BAT) Restarting
system
Battery charging
GSM/GPRS in use
Medium coverage
Local line in use
FLASHING
QUICKLY
N/A
Battery failure
Missing PIN/PUK
Missing PIN/PUK
N/A