ATH-Heinl M72Z Plus Bedienungsanleitung Seite 77

1.3.6 Assembling a tyre
In principle, the guidelines of the German Rubber Industry Trade Association
(Wirtschaftsverband der deutschen Kautschukindustrie) should be observed when
assembling tyres.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-10
After disassembly, press down on the gear change pedal to move
the assembly tower so it swivels back.
Then remove the tyre.
The tyre valve should be changed before assembly.
Clamp and/or set the wheel rim so that the wheel valve is
approximately 180 degrees over the assembly head.
Cover the tyre and the wheel rim in a sufficient amount of assembly
paste.
Manufacturer ATH-Heinl GmbH & CO.KG
- 19 -